ESP32-S3-PLUS is a high-performance development board with appearance aperture compatible with for R3/R4, based on the design of ESP32-S3-WROOM-1-N16R8 module, the ESP32-S3-WROOM-1-N16R8 module owns 16MB Flash and 8MB PSRAM, which can store more codes and data, the module is equipped with ESP32-S3 chip which has powerful neural network.The ESP32-S3 chip equipped in the module has powerful neural network computing ability and signal processing ability.It supports Wi-Fi and Bluetooth 5.0 dual-mode communication, which reduces the difficulty of device networking, and also supports Bluetooth Mesh protocol and Loxin Wi-Fi Mesh to realize higher communication stability and larger coverage area. Home industry unified standard devices, applicable to a wide range of IoT scenarios.It can be programmed using for IDE, ESP-IDF, MicroPython, C language, python can easily manipulate the hardware.Adopts ESP32-S3-WROOM-1-N16R8 modules.Built-in ESP32-S3 series SoC, Xtensa dual-core 32-bit LX7 microprocessor.16MB Flash, 8MB PS RAM, 384kB ROM.36 GPIO portsOn-board PCB antenna with external antenna supportSupports 802.11b/g standard 2.4GHz Wi-Fi, Bluetooth 5.0Data Rate 150MbpsADC, GPIO, IC, IS, SPI, PWM, UART, USBDC header voltage supply 7-9V, USB interface supply 5VOperating Temperature -40C - 65C (TA)Colour:BlackMaterial:PCB+electronic componentsPackage Contents:1 x ESP32 S3 PLUS Development BoardOnly the above package content, other products are not included.Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.