Brushed ESC 24V 48V 60A High Voltage Brushed Motor Speed Controller for RC Model Cars -- Description -- - This ESC is widely used in RC tanks, RC cars, RC crawlers, RC trucks, RC boats. - Can go forward/backward. - Support wide voltage and high voltage input, up to 60V. - Automatically find neutral point. Please note: UBEC is a switch mode regulator, do not use two ESCs in parallel to power the receiver, otherwise they will be burned. The correct way is to disconnect the positive line of one ESC. If the receiver is powered by other modules, please disconnect the positive line of this ESC. How to brake: The throttle lever moves back a little beyond the neutral point, and the motor stops by braking. When the motor is running forward, pull back the throttle and the motor will reverse immediately. Throttle range setting (throttle range calibration): Move the throttle stick to the full throttle position, then connect the battery pack to the ESC. After 2 seconds, the indicator light flashes twice, indicating that the full throttle position has been confirmed. After the full throttle position is confirmed, the throttle stick must be released to the neutral position immediately. The indicator light flashes three times, indicating that the neutral position has been confirmed. How to use: 1. Connect the receiver, motor, and battery correctly. 2. Turn on the ECS power supply, and the LED flashes once. 3. Push the throttle stick to the neutral point, turn on the transmitter, and adjust the throttle stick/fine-tune until the LED flashes once. Indicates that the neutral position has been confirmed. Motor limitations: When using a 24V battery, the power is 350W and the speed per minute is 4000rpm. When using a 36V battery, the power is 500W and the speed per minute is 4000rpm. When using 48V battery, power 650W, speed 4000rpm. - Specifications and Features- - Working voltage: 10V-60V (3s-13s for lithium battery), supports secondary battery. - Continuous current: forward 60A, reverse 60A - UBEC: 5V/0.5A - Weight: 110g - Signal connector: cable length about 20cm - Dimensions: 8.3cm x 5.0cm x 2.0cm - Connector: XT60 optional -- Product Includes- 1 piece 24V 36V 48V 60A brushed motor speed controller ESC for remote control car, tanker, boat, crawler Easy to use, no manual required.